Nintendo Arcade Push Button

thingiverse

I salvaged the dimensions from my vintage push button on my Nintendo Playchoice 10 arcade cabinet, figuring it's likely the same switch used across most Nintendo arcades of that era. It turned out super glue easily fixed the original switch, so I never actually needed to print a replacement. Still, this design might prove useful for someone else down the line. My initial plan was to print the part upright with supports under the overhangs, aiming to keep the top surface looking sleek and clean. This design should work seamlessly with the original spring in place, thanks to its M16 thread compatibility. However, I'm still uncertain about the size of the original e-clip used; the design is optimized for a 6mm e-clip as an alternative.