Nimble and Sidewinder V2 mounts for the Creality type print heads

thingiverse

Modular print head mounts a Nimble V2 or Sidewinder V2 on Creality type print heads, covering a wide range of printers. The Standard hot end mount is compatible with both original and MicroSwiss hot-ends. In total, the Standard, MicroSwiss, E3D-V6, and Mosquito hot-ends are supported. For E3D-V6, choose to use standard fan and duct or different shroud and install a 40x40 fan. The Mosquito mount can hold standard fan or a 40x40 fan. Since the introduction of Version 2 of Nimble and Sidewinder, they share mounting points. This means that these mounts are suitable for both Nimble V2 and Sidewinder V2. The Nimble V2 has a drive cable exiting vertically, while in the Sidewinder V2 the drive cable exits horizontally. Changelog: - Initial release. - Tweaked BL Touch sensor to give it more space with 5015 duct. - Added a mount for standard Tornado hot-end. - Modified CR-10 standard hot end mount. One nut pocket was off-center. - Added a PDF describing various options. - Tweaked slots in V2 Ducting 5015, allowing more space for Volcano hot-end. - Added Dual 5015 duct (You guys like a lot of wind!) Only for V6 and Mosquito mounts. Various M3 fasteners are needed, depending on which version is required. For USA friends, it's easiest to buy a kit like this: [M3 fastener kit](https://www.amazon.com/iExcell-Metric-DIN912-Stainless-Assortment/dp/B07J44YXV3). STL models are checked and optimized. Parts that need different orientation to print properly are rotated to preferred printing position. The Nimble Extruder Version 2 These parts are **ONLY** for the Nimble and Sidewinder Version 2. With an installed weight of less than 25 grams on carriage/effector, the Zesty Nimble is the smallest and lightest extruder you can buy, it has ample torque and can be mounted in multiple orientations. The Nimble is available from [Zesty Technology.](https://zesty.tech)