Nikon HB-69 18-55mm VRII New lens hood

myminifactory

This hood is designed for the new Nikon 18-55mm VRII lens, which features two prongs. In contrast, other similar designs found online typically have three prongs and will not fit properly on newer lenses. This particular design also allows for easy storage by being reversible, just like it was originally intended to be. The camera in the picture is a Nikon D5500 with an 18-55mm VRII lens attached. The print settings used were as follows: Printer - TEVO Tarantula, Rafts - None, Supports - None, Resolution - 0.15, Infill - 20%, Print Speed - 60, Nozzle - 210, Heat Bed - 60. Pre-printing tip: Start by printing a few layers and then pause the print to check the size of the printed ring with your camera lens. If it's correct, you can reprint a new one; otherwise, adjust the design to get it right on the first try. Post-printing note: Depending on the accuracy and calibration of your printer, you may need to sand down the prongs slightly to achieve a smooth fit. If the hood is too tight, you can use a hair dryer or heat gun to warm it up and then let it cool into place.