Nikon Eclipse Ti2 Light Shield

Nikon Eclipse Ti2 Light Shield

prusaprinters

Light shield designed explicitly to fit a Nikon Eclipse Ti2, attaching directly to the lens barrel.Contrarily to the original "light shield", this accessory blocks light coming from all sides, allowing operation in a fully lit environment. Can be left permanently attached, and even when installed at the lowest possible position doesn't significantly reduce the moving plate's range of motion.MaterialsM6 tapPET is recommended for the collars (inner and outer rings).A strongly black material should be used for the shade.PrintingPrint all parts with a 0.4 nozzle and 0.2 layer height (or lower).AssemblyUse the M6 tap to thread the hole on the outer collar. Insert the screw and ensure it can move smoothly throughout the entire thread:Bend the inner collar with your fingers as shown below:While keeping the inner collar bent, insert the shade:Then insert the outer collar and release. Ensure the screw is aligned with the slit on the inner collar.Lift the lens head on the confocal and insert the assembly directly on the lower barrel, larger diameter section. The lens barrel should still protrude by roughly 2cm and hold by itself:Tighten the screw to avoid further movement. Only minimal tension should be used.

Download Model from prusaprinters

With this file you will be able to print Nikon Eclipse Ti2 Light Shield with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Nikon Eclipse Ti2 Light Shield.