Nightlight Late-Night Edition

thingiverse

A revolutionary nightlight based on jjpowelly's visionary design (Thing 905142). This innovative remix boasts an enlarged case designed to house a plug, an Arduino to control RGB LEDs and touch sensors that allow users to adjust brightness and effortlessly switch between a dazzling array of light effects. In-depth build instructions are available in the Nightlight Late-Night Edition blog post. A crucial note: this project involves powering electronic components with a 5V supply using a mains circuit (230V > 5V) connected to a power plug (230V). If you plan to build this, it is essential that you understand voltage insulation and safety protocols. In the event of uncertainty, consult an expert or modify the design to utilize an unaltered line adapter or batteries. Disclaimer By printing and using this model, users assume full responsibility for any potential risks or damages. I disclaim all liability for injuries or damage caused by the use of this model. Print Settings Printer Brand: Ultimaker Printer: Ultimaker 2 Rafts: No Supports: No Resolution: .16mm Infill: 22% transparent - 100% black Notes: Printing the plate with dual extrusion is unnecessary. Simply print the plate and inlay separately, then use a rasp to create a snug fit between the parts printed together with the plate. Finally, press these parts into the plate.