NieR Automata - YoRHa-issue Blade

cults3d

This model is cut into 6 parts to fit in a printer with a platform size of 200mm x 200mm x 200mm. Each part is then sliced in half for easier printing. There is a picture with pieces labeled to their file name in the preview section which you can refer to. There is an uncut version included as well just in case you need it. Tunnels with a diameter of 10mm were also punched on the model for alignment and bone installation purposes. You can skip removing those support if you are not planning to use any support for the crafting. Please be extra careful when removing those supports from the tunnel as they are quite close to the surface of the model. Remove with caution to prevent breakage on the surface. There is a "peg" file, a cylinder with a diameter of 9.5mm included just in case you need it for the purposes mentioned above. Once pieces a and b are printed, glue them back to back to form a part. Repeat the same for the other pairs and join all the parts afterward. For scaling, please use the same scale for all the pieces. Cheers and Happy Printing!