Nexus 6 & Anker Qi Wireless Charger Stand

thingiverse

I made this thingy in Sketchup, so be nice it's my first time.\nThe stand is designed specifically for a Nexus 6 Phone with a Bumper Case and the Anker Qi Ultra Slim Wireless Charger attached.\tWhile it might work on other phones, I set the Qi holder to fit perfectly on my Nexus 6. The setup may not be correct for wireless charging on other phones though.\nYou'll see that the Charger Holder part is made of thin flexible plastic but since the pressure of the Nexus 6 Phone against it isn't very strong - most stress actually lies below on the stand. \nThe ring surrounding the charger suppresses an irritating flashing blue and green light as soon as it's charging the phone.\tI'm curious about hearing from anyone who creates this project - I'll take any improvement suggestions into consideration. Print Settings Printer: Convenient 3D Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: .2mm Infill: 30% Notes: Printed it using the following settings for added stability: Shell Thickness: .9mm Bottom/Top Thickness: .9mm Infill: 30% When I printed, Cura insisted on generating a support under the overhanging very top part but since it looked pretty stable with only 65 degrees of 'Overhang angle for support' used, and there was no drooping.