Nexus 5X Car Mount 2

thingiverse

Update (11/26/16): Uploaded SketchUp file and added STL version without Nexus logo. This caseless Nexus 5X holder fits onto a common 4-tab or 4-hole GPS/phone car windshield mount base. Print Settings: Printer Brand: Printrbot Printer: Simple Black Rafts: No Supports: No Resolution: 0.2 mm Infill: 25% Notes: Filament used is MakerGeeks Raptor Battleship Gray PLA, with hotend temperature at 235 C and bed set to 70 C. Printing speed was 45 mm/s with a fan enabled. Shells and perimeters were set to three each, and top and bottom layers also to three. Slicing software used was Cura. Post-Printing: If the first layer(s) are squashed out wider than the rest, the edges of the tabs and square holes might need trimming with an X-acto knife or sanding/filed down before the mount snaps into place.