Nexus 5 DIY car wireless charger stand

thingiverse

I've installed my wireless charging stand for my Nexus 5 in my Skoda Yeti. To secure the stand, I utilize the slits between the radio and panel, as well as between the blower and panel. The distance between the plates is adjustable, making it compatible with other vehicles. Additionally, I employ a long M3 screw (40mm) and two M3 nuts with nylon stoppers to provide extra stability. For the back plate, I use four small screws for secure attachment. The wireless charging electronics are from eBay: http://www.ebay.com/itm/131626000948?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT I utilized the following print settings: Printer Brand: RepRap Printer: Prusa i3 Rafts: No Supports: Yes Resolution: 0.2mm Infill: 35% Notes: I printed the phone holder base with its bottom facing down on the print bed, which took a bit longer but eliminated the need for supports in that section where the phone slides in. However, in the back section, where the electronics are located, support was necessary due to space constraints.