Nextion enhanced 3.2 in touch mount for 3/4 in panel

thingiverse

If you're building a MAME panel and need a flush mount option for your 3.2 Nextion display, this is designed specifically for you. The lip covers up imperfections of the cutout, so it doesn't have to be perfectly clean. You'll get four 5/8-inch screws from your local hardware store to secure the cover and board to the bottom. This design mounts from underneath, with wires terminating out the back or bottom. There's no cutout for the expansion on the right side, but there is a cutout for the main connector: 5V, GND, TX, and RX. I'm not actively working anymore due to recent events, but tips are not mandatory - they're greatly appreciated, though. This design is intended for personal use only. If you need more information, here are some print times on an Ender 3 Pro: * CoverW Lip.stl (the top part): at .12, approximately 3 hours and 45 minutes; at .20, approximately 2 hours and 10 minutes. * Bezel flush mount: at .20, approximately 6 hours. The bottom piece has oval holes to allow for slight adjustments if needed.