!!NEW VERSION!! Cable Chain Anet A8 X-axis between Chassis and Z-axis

thingiverse

Since the Thingiverse team is unfortunately unable to get their ongoing technical problems under control, I decided to change the portal. My projects published here are no longer maintained by me. All projects have migrated to the new platform and can be downloaded there. Please visit me on my new page: https://cults3d.com/en/users/CoffeCup/creations Version 2020 - Cable management for the X axis of the Anet A8 The chain runs along between the Z-axis guide and the chassis, ensuring good access to the filament and all units of the HotEnd. For an Anet A8 printer, you need 28 chain segments. The bracket on the engine side is a combination of an existing thing file and my own development. New in this Version 2020 is the adjustment unit. Each point on the knob corresponds to 0.1 mm height adjustment, ideal for frequent printing on different surfaces (tape, glass, etc.). It's essential that you print the part "Knauf_Lagerbock" in high quality and possibly with a nozzle of 0.3 mm. Additionally required: - Threaded rod or screw M3, 45mm long - Spring from a ballpoint pen - 4 nuts M3 - Glue / screw safety lacquer Please note that without extending the cables, the maximum build height is limited to approximately 150mm. Check it out here too: https://www.thingiverse.com/thing:3319190 - Riemenspanner X-Achse https://www.thingiverse.com/thing:2844515 - Kettenglied Kabelschlepp https://www.thingiverse.com/thing:3817134 - Filament-Brake https://www.thingiverse.com/thing:2884990 - Kabelschlepp X-Achse Version 2020 - Kabelschelpp for the X-Axis of the Anet A8 The chain runs along between the Z-axis guide and the chassis, ensuring good access to the filament and all units of the HotEnd. For an Anet A8 printer, you need 28 chain segments. The bracket on the engine side is a combination of an existing thing file and my own development. New in this Version 2020 is the adjustment unit. Each point on the knob corresponds to 0.1 mm height adjustment, ideal for frequent printing on different surfaces (tape, glass, etc.). It's essential that you print the part "Knauf_Lagerbock" in high quality and possibly with a nozzle of 0.3 mm. Additionally required: - Threaded rod or screw M3, 45mm long - Spring from a ballpoint pen - 4 nuts M3 - Glue / screw safety lacquer Please note that without extending the cables, the maximum build height is limited to approximately 150mm. Check it out here too: https://www.thingiverse.com/thing:3319190 - Riemenspanner X-Achse https://www.thingiverse.com/thing:2844515 - Kettenglied Kabelschlepp https://www.thingiverse.com/thing:3817134 - Filament-Bremse https://www.thingiverse.com/thing:2884990 - Kabelschlepp X-Achse