New Display Frame for my Case-System (Ramps/Rumba)

thingiverse

New Display Frame: The Black Border of the display is now covered, allowing Boards with "short" dial-encoders to be used, but you need to take the knobs from this set for that case. This frame is 2mm higher than the original frame. The reset knob has been extra-made specifically for this frame. The display PCBs are sold in two different versions: (take a look at picture 5) The flat low-profile display features a 6mm red PCB, while the high, tall display features an 8.4mm green lower pcb Mounting the Flat Display Version: (picture 6) You need 4x M3x12mm screws to mount the display in the upper frame. Then, screw the upper frame to the lower frame with the remaining 4 screw holes. Mounting the Tall Display Version: (picture 7) The 4 holes on the PCBs must be used. In this case, you take the frame, lay the display inside it, put the backplate on top, and then secure everything together using 4x M3x20 screws in the backplate. Alternatively, you can use 2x M3x25 screws if you want to tilt the Display. Post-Printing: The display PCBs are sold in two different versions: (take a look at picture 5) The flat low-profile display features a 6mm red PCB, while the high, tall display features an 8.4mm green lower pcb Mounting the Flat Display Version: (picture 6) You need 4x M3x12mm screws to mount the display in the upper frame. Then, screw the upper frame to the lower frame with the remaining 4 screw holes. Mounting the Tall Display Version: (picture 7) The 4 holes on the PCBs must be used. In this case, you take the frame, lay the display inside it, put the backplate on top, and then secure everything together using 4x M3x20 screws in the backplate. Alternatively, you can use 2x M3x25 screws if you want to tilt the Display.