Netgear Switch Table Mount (Customizable)

prusaprinters

This is a five minute make of a table mount for my 48 port Netgear FS752TS switch. I know I printed more than needed. Three of them were enough. Two wide on the size and a small one on the back. You may want to use another small one with a less tightened screw to block the device from being pulled out to the front. If managed to get the mounts quite narrow, so the switch is not moving, when pulling the wires. Probably only useful for other devices, when customized. Luckily I added the FreeCAD source file, which contains the measurements for easy modification. If you don´t know how to customize, please checkout the simple guide I made for my Sonoff Touch Frame. https://www.thingiverse.com/thing:2888143 Happy Printing PS: Yes, I know I have to add some cable management, but there aren´t not all network cables reattached, so later. Print Settings Printer: Anet A8 Rafts: YesSupports: No Resolution: 0.2Infill: 40% Notes: You can probably print without rafts as a little lifting does not matter, as the mount is under the table. However this is a customizable mount and you may want/need it to look good. Category: Computer