Netgear CM600 / CM1000 Wall Mount

prusaprinters

<p>I needed to rework and mount as much of my networking gear as i could which necessitated removing the modem's stand and constructing a wall mounted solution.</p><p>The most important goal for me was to make the simplest print i could while not impinging on the modem's heat dissipation. I had a few prototypes that basically had no covering over the top of the case but used a huge amount of support material. In the end I decided to go for a simpler off-set solution that has been working for me over the past month or two in my well air conditioned house. YMMV</p><p>I've included a perforated and non-perforated version just in case you are interested. make sure to print off one for the top and another for the bottom.</p><p>Works on my original and upgraded CM series modem - both of which are ~44mm thick.</p>