Nespresso capsule holder version 2

prusaprinters

<p><strong>Updates compared to version 1.</strong></p><ul><li>Center shaft increased to hold sleeve&nbsp;</li><li>New base for stability and to deploy capsules from sleeve.</li></ul><p><strong>Build</strong></p><p>Top section requires a brim for stability</p><p>Bottom section I placed three support paint on enforcer points to support the bridging across then opening.</p><p>After the top section is built you need to remove all the excess brim and open the gaps in the bottom. Probably don't need the inner brim.</p><p><strong>Assembly</strong></p><p>Fitting the top and bottom section requires all side to be equally inserted.&nbsp;</p><p>The tolerances are very tight and it is difficult to start but it will go (eventually).</p><p>It needs a little force to push together after lining up each side.&nbsp;</p><p>&nbsp;</p>