Nerf Zeus Picatinny Side Rails

thingiverse

These are interchangeable Picatinny side rails for the Nerf Zeus, designed for straightforward installation. To secure them properly, simply drill holes into the shell and fasten with a nut and washer. From experience, if you're not using a nylon-reinforced ring nut, thread lock is essential to prevent vibrations from loosening the nut over time. I chose screws because I often see these blasters without rails, leading me to believe that the existing clip setup may not be secure enough. Side 1 (smaller rail) - might need supports near where it touches the hotbed due to two small overhangs at each end. The larger overhang should face towards the rear of the blaster. Side 2 (larger rail) - doesn't require any supports. To fit this rail, remove a bit of one internal screw mount and then drill into place.