
Nerf Worker Talon Adapter - Fully Forward
thingiverse
Talon mag adapter that sits fully forward and features a lever release. Warning: This adapter is not compatible with all magwells. You may need to use snips/flush cutters/file/etc. to cut down the front of the magwell. Warning: No prevention of over-insertion whatsoever. The top of the blaster's magwell must provide this when inserting Talon mags. Warning: Magwell is not flared. The mag and magwell fit varies by blaster, so you may get tagged in battle if not modified accordingly. Should be Compatible with Raider Requires Cutting for Stryfe, Sentinel Not Compatible with Caliburn, Hail Fire I will only use this adapter initially on the Raider/Rampage but might try it later on the Stryfe and thus support it. Marked as work-in-progress since I still need to fine-tune the fit against the magwell itself. The fit will vary depending on the blaster used. Hardware: - Compression Spring: No specific size recommendation, but should be smaller than 5mm diameter and approximately 10-11mm long. You'll have to experiment with sizes that work best for your setup. - 2x 4-40 x 3/8" Countersink Screws: These screws are used to mount the insert. Superglue can also be used, but it's a permanent solution! Print without supports. A built-in model support is included at 0.3mm above and below to support the mag release notch in the body piece. No other supports are required. Thanks to Worker, Captain Slug, and Project-FDL for their design inspiration.
With this file you will be able to print Nerf Worker Talon Adapter - Fully Forward with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Nerf Worker Talon Adapter - Fully Forward.