NERF Super Soaker Tank

thingiverse

NERF Super Soaker scatter blaster Mod Add an extra water tank to your NERF Super Soaker perfect for summer. The Tank uses the existing cab and is easy to install and removable. https://www.target.com/p/nerf-super-soaker-scatter-blast-water-blaster/-/A-49126116 -Print left and right part of tank with supports. Turn off rafts or skirt to make it fit an Ender 3 bed, two layers and 30% infill is enough to get it waterproof. -Remove supports and clean up the glue surface. Make sure alignment pins are not too tight. I used CA gel super glue and a few clamps. -Print screws and bulge parts for decoration and glue in place. -Remove existing tank cap on NERF gun and attach it to the tank. It might need some sanding to make it fit depending on your support and printer settings. -Slide tank in place from the back until it clicks in place. Fill tank and have a blast. For extreme play, add a rubber band to secure the tank. Best to share with kids too! Let me know what you think and how yours came out. Post pictures of your make. This was a fun project to design for me and my son. I learned a lot and wasted a lot of filament to get it to fit.