Nerf Sledgefire Single Shot Shell V1.1

thingiverse

This is a single shot version of the standard rear loadable shell. One barrel is left open while the rest are sealed, and a centered version will soon be available for use. There's a slight issue with the base, but it will still fire; however, closing the breech can be quite challenging. This problem will be resolved in an upcoming update, so I recommend holding off on printing until then. Update 1.1 adds room to allow for better sealing of the shell onto the cylinder. For Version 2.0, please visit: http://www.thingiverse.com/thing:2230107 Print Settings: Printer Brand: Wanhao Printer Model: Wanhao Duplicator i3 V2 Rafts: Yes Supports: Yes Resolution: .2 Infill: Not critical at 50% Notes: Print the rear of the shell with the top facing upwards. My first print yielded a good seal, but my second attempt didn't quite work out as well, so you may need to sand or smooth the edge. Printing with ABS material would be beneficial due to its smoothing capabilities.