Nerf Rival Apollo Pump Kit Split Primer Arms

prusaprinters

<p>This is a version of the priming bars split in half with a joint in between and laid flat for printing on smaller printers. Layer lines should also be stronger in this orientation. However, the joint location is a new potential weak point and may need reinforcement and revision. Joint may also need wider tolerance to fit without sanding. May need an additional reinforcement part I might design in the future.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Creality</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Ender 3</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p></div> <p><strong>Resolution:</strong></p> <p>0.2</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>30+ Recommended</p></div> <p><strong>Filament:</strong> Hatchbox PLA Black</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>Printed with a brim to help hold the small support in place. Should be mirrored and printed again for opposite bar. Not yet stress tested and higher infills are recommended for strength. First prototype was at 20% and it isn't finalized.</p></div> Post-Printing ============= <p>Sanded and superglued to get joint to fit.</p> </p></p></p> Category: Hobby