Nerf N-Strike Folding Stock Adapter

prusaprinters

Thanks for checking out my design!This item is sold fully assembled on my Etsy store: https://www.etsy.com/listing/1743017114/nerf-n-strike-folding-stock-adapter?ref=listings_manager_gridYou will need some Loctite superglue and a ~9mm Outer diameter, ~7mm Inner diameter, ~20mm length, ~1mm wire circumference spring. A suitable spring can be purchased here: https://www.mcmaster.com/8969T756/. You can also find these springs in an assorted spring pack from a hardware store.All prints are given custom supports to save time on post processing. Please keep supports off in your slicer settings.pin and reinforcements1 and 2 should be laid flat and then super glued into your female piece to ensure the hinge is strengthened and won't rely solely on layer adhesion.Lay the female piece on the build plate with the side with the tab facing down. For the male piece, lay it so the stock attachment point is oriented upside down, and the custom supports I added are touching the build plate.