Nerf Mega Bigshock Inline Magazine (inline clip)

Nerf Mega Bigshock Inline Magazine (inline clip)

thingiverse

This is a 4-shot inline mag for the Nerf Mega Bigshock. It lets you load 3 short (3.5mm) darts into the mag and one in the barrel. To reload, tip the barrel down while priming and then fire away. Materials: You'll need this print One 40mm length of 17/32 brass tube Some tape or glue First, remove the AR and dart post using your preferred method but make sure you have a clear path to the back of the blaster. I used a flathead screwdriver to pry the cap off the back of the barrel. If done carefully, it can be glued back on or printed again. Eventually, after test-fitting all parts, glue one in. Once you have a clear path to the back of the blaster, test-fit the print and use some tape to get an airtight seal and allow the print to seat fully. Also, ensure the sight is on top, and the channel lines up with the plunger tubes air hole. The next step is to cut 40mm of 17/32 brass tube. Sand all rough edges smooth so a dart can slide in without catching. Test-fit the brass in the end of the print; it should seat on a lip inside. If not airtight, try adding a layer of tape or glue. In the end, you may want to glue the print into the blaster for a perfect seal but I'm getting acceptable performance without gluing the print in the blaster or the brass in the print. This is my first from-scratch design, so let me know how it performs and any feedback. Maybe I'll do some strictly visual remixes just for fun, but one of you may beat me to it!

Download Model from thingiverse

With this file you will be able to print Nerf Mega Bigshock Inline Magazine (inline clip) with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Nerf Mega Bigshock Inline Magazine (inline clip).