NERF Front grip with Sipik SK-68 holder

thingiverse

I made this flashlight holder for my NERF guns (http://www.thingiverse.com/thing:1156002), but I wasn't satisfied with holding my Stryfe in front of the mag, so it was awkward either way without or with the flashlight holder. That's why I created this new design. I designed it in OnShape: https://cad.onshape.com/documents/877106419f539d625bdd0e6f/w/13a1e1cc17430f1adb0d5fbb/e/a447fddd71da6ab6d8779c6b Print Settings: Rafts: No Supports: Doesn't Matter Resolution: 0.2 Notes: I strongly recommend using a 0.2 mm layer height because there are supports with a 0.2 mm air gap for easy break-off. Post-Printing: Grip the bottom support below the flashlight holder and snap it off. Take a wide screwdriver and insert it into the hole at the spring tab, breaking it loose without overdoing it. There is a removable support in the hole; if it's not in the way, you can leave it alone. If the spring tab won't flex back, bend it forward and backward a few times to wear down the edges slightly.