Nerf Doublestrike Trigger mod

thingiverse

This mod is for the Nerf DoubleStrike pistol. Please read all notes carefully before printing and consider sharing the print / notes if you create it! The pin holes may need to be drilled out slightly after printing, which was done to maintain a smooth snug fit for the part. After printing, I discovered that the following steps are helpful: 1. Place the trigger spring in the trigger hole (smaller) and align it with the larger hole on the trigger. 2. Slide the trigger axle through the spring & large hole on the trigger shoe. 3. Rotate the trigger so it's almost upside down, then rotate it counter-clockwise to lower the trigger and spring into the frame, which should allow for a firm trigger spring. You'll need to work the trigger down as you lower it onto the axle. 4. Have fun! *********READ THIS*********** Make sure to take note of the small spring under the trigger when disassembling the inside of the gun. If possible, capture an image of its correct position, as I made an educated guess about where it should be located. **********************************