Nerf Dart Compatible Drain Blaster

thingiverse

Human: A versatile adapter enables you to launch Nerf Darts with a drain blaster through specialized capsules. Instructions: Printing: 1st Side: Print the side that connects to the drain blaster, using supports and 50% infill for four perimeter layers. 2nd Side: Print the side that connects to the drain blaster, using supports and 50% infill for four perimeter layers. Single Shot Capsule: Print on the side that connects to the adapter, using supports and 5% infill for four perimeter layers. Triple Shot Capsule: Print on the side that connects to the adapter, using supports and 5% infill for four perimeter layers. Ten Shot Capsule: Print on the side that connects to the adapter, using supports and 5% infill for four perimeter layers. Assembly: Materials needed: Six M3 screws, 25mm long or cut to fit Six M3 nuts Twelve 3mm washers One 15mm x 2.5mm O-ring Two 60mm x 2.5mm O-rings (per capsule) Main Blaster: Place the drain blaster between the first and second side. Add a washer to each screw, then screw them in. Before tightening the nuts, insert another washer on each screw, so that there is one washer on either side. Secure the nuts tightly. Capsule: Place two large O-rings in the designated slots. WARNING: Do not aim or shoot at heads or eyes! Use this adapter at your own risk!