Nerf 7 Shot Absolver Shell for 1.25" PVC Fittings

thingiverse

Update: After a lengthy wait, these updates are finally live. Following feedback, the ID of the "barrels" has been increased to 13mm in an effort to achieve a better fit. As a result, the shells can no longer fit inside 1.5" PVC pipe due to the overall increase in size. The OD of the shells is now 42.2mm compared to 42.418mm for 1.25" fittings. Three different versions are available: - 7shot_13mm_shell_insert: This is the barebones "barrels" of the absolver, designed for those who want to save print material and time by using 1.25" fittings to make complete shells. A hotglue or other space-filling material will be needed between the "barrels" and the fitting. - 7shot_13mm_shell_capped: This version has a filled circle on the end to roughly seal inside 1.25" fittings. It is recommended for users who have a 1.25" fitting on their blaster and want to fit shells that should be a press fit. - 7shot_13mm_shell_capped&indented: The same as above, except with an indent in the circular end to give more flow to the outer barrels. This is suggested for users whose exit of the tank is smaller than 1/2" or is butted up against the back of the shell while in use. This one is a little more difficult to print due to the indent. This "shell" provides an easier way to have absolver shells ready for higher powered blasters. It is designed to be a friction fit inside of 1.5" PVC pipe, which is cheaper and easier to come by than 1.25" PVC fittings. An updated version has also been added that should fit 1.25" PVC fittings and features a taller base for a more snug fit. The dart barrels have a barely looser than CPVC fit on darts (.490" vs .485"). I haven't printed this yet to test, so it may need some fiddling with settings.