Neptune 4 series spool holder panel/wall mount

thingiverse

This is a mounting bracket for the stock spool holder found on the Elegoo Neptune 4 / Pro / Max series. I am not sure if it's the same model as the previous Neptune 3 series, it was only tested on my 4 Max.The original spool holder has a lip on the mounting end, preventing you mounting it to walls or panels. The intended placement in my case was inside an IKEA Melltorp table enclosure so to have internal access to the spool while keeping a compact space.If you place the holder within reach, you can still mount the filament sensor on it by pulling the cable out from the printer frame (see pictures).I also included a washer model for 4x40mm countersunk screws, which is what I used for my specific case.Note: because of how the spool holder is manufactured, there's a slight taper to the piece in one direction. I did not account for this, since the mold taper angle can vary from piece to piece, but you may notice small plays or gaps between the print and the holder.