Needle Puller

thingiverse

This is a simple yet effective tool for safely removing needles or pointers from gauges and clocks without causing any damage. To create this needle puller, I used a Cap Screw Head M5 25mm to push down on the pivot or pointer shaft of the gauge. A fine tip at the end of your bolt is necessary; 1-1.4mm should be sufficient. If you have an M5 thread tap, you can use it to start threading in the body of the puller. You can also print a decorative handle for the cap, which fits snugly and requires only a slight turn as you push it together. Print Settings: Printer: Duinotech Rafts: No Supports: No Resolution: 0.3mm Infill: 100%