Needle Point Meter Probe Case

thingiverse

These are cases for snap-on needle points that fit meter test leads perfectly. There are two sets of files available, one specifically designed for Fluke needle points and the other for Keysight/Agilent/HP needle points. I printed these cases using PLA yellow filament, which has a semi-transparent quality allowing you to easily see if the needle points are in place. If the bore inside the case is too tight, you may need to adjust the X-Y scaling in your slicer software. Remember to make adjustments incrementally by 0.1 at a time to avoid compromising the design's integrity. It's also essential to scale the cap simultaneously as it just snaps onto the layer lines for secure fitment. I have personally experienced great success with this approach. To achieve optimal results, print these cases slowly at a speed of 30mm/s. Print settings include: layers set to 0.2mm and no support required. Refer to the accompanying photos for detailed print positions.