Needle for Hornet with support bed

thingiverse

This is just the weapon for Hornet from WalRit's excellent Hollow Knight & Hornet figures. Experiment in your slicer with the layer height to get the best point on the needle and proper support posts under the needle (note that they can disappear entirely at some settings). Print without supports -- the supports are built in to the file. After printing you will need to cut any remaining support post material with an exacto knife. There is a photo attached here showing the parts just after they've been separated. I've posted OBJ and STL versions, they are identical other than the file type. I was having a hard time getting the needle to print (WalRit and others suggested printing vertically but my needle's tip was always bent); then I was having a hard time gluing the needle on to Hornet's hand so I enlarged the notch slightly (using WalRit's figure). You may note that there is quite a bit of support, feel free to modify this for your own use. You can do it for free online on Tinkercad: https://www.tinkercad.com/things/5EyGWnWiYyT