Nectar Collector Stand

thingiverse

My own Nectar Collector Stand This was designed to hold an Aleaf Mega Series Tower with Barrel Perc after use while it is still cooling down, but there are others that will fit as well. It can be printed in one piece with the shaft against the ground to avoid using supports. The stand holds the collector by the neck very securely. It has a spot for a small jar that came with it and a smaller hole to hold a dabber. The gap between the hot end of the collector and the base plate is small, but still big enough to slide the jar in and out from under it. It was sliced in Ultimaker Cura 5.2.1 with standard 0.2mm settings. It was printed entirely in PLA and is holding up very well. So far, there has been no sign that this thing should ever break from its intended use. In time, I may tweak this model and break it into 3 pieces that will snap together so each piece can be printed in the proper orientation for maximum strength.