Necklace Stand with spider web at top

prusaprinters

<p>This a necklace stand I designed to hold 16 necklaces. I wanted to make it a little more interesting to look at, so I added the spider web design at the top. I used a 11.5" long 3/8" oak dowel for the support, but you can print a plastic dowel if you prefer from the included file. The widest part is slightly less than 200mm. I also included a test part so you can check whether the hole prints the correct size on your printer. I still had to sand the dowel a little so it had a nice slip fit &amp; would turn easily.</p> <p>There is an updated version of this design located here: <a href="https://www.thingiverse.com/thing:1054244">http://www.thingiverse.com/thing:1054244</a></p> <h3>Instructions</h3> <p>Print the test part 1st to make sure the hole will be the correct size.</p> <p>If it needs adjusting on your printer, create a new test part by changing the P38ID variable size in the file TestDowelAndHoleSize.scad &amp; reprint. If you are going to use a 3/8" dowel, you do not need to print the plastic dowel part.</p> <p>After you are happy with the sizes being correct.</p> <ol> <li>Print the NecklaceStandTopWithStraightHooks_rev12_repaired.stl (this part took 3 hours &amp; 50 minutes on my printer &amp; weighs 2.2oz)</li> <li>Print the NecklaceStandBottom_repaired.stl or receate this file changing the P38ID variable in the corresponding openscad file</li> </ol> <p>(this part took 1 hour &amp; 30 minutes on my printer &amp; weighs 0.8oz) 3. If you want to use the plastic dowel, which I made 8 sided, print the length you want. You can print the dowel diagonally on your build plate if it will fit better that way. The stl files are generated that way. I used a 11.5" long 3/8" Oak dowel instead of using the plastic part, since I had some &amp; thought it would be better than plastic. I have not tested using the plastic dowels, but included this in case someone wanted to use all plastic.</p> <p>I printed this in PLA at layer height of .2mm &amp; infill of .2 &amp; brim of 4 using Slic3r 0.99.</p> Category: Jewelry