NEC Multisync 3D VGA Connector Hood

thingiverse

The tabs that held the VGA connector in place were broken, so I modeled this replacement VGA hood (or I think it should also work for DE-9 versions) for my NEC Multisync 3D. Might work for other NEC monitors of the same era, I'm not sure. Reuses all hardware from the original hood. I didn't think an off-the-shelf VGA hood replacement would work correctly due to the small PCB contained inside. I printed with supports only on the inset screw holes. Nuts go in the bottom/flat piece, due to some design shenanigans the top hex holes are too large to hold them in place and I didn't feel like fixing that... Not for commercial use.