Nebra LoRa Antenna Wall / Window Mount

prusaprinters

This is a window or wall mount for the Nebra LoRa antennas, specifically tested with their 50cm long 5.8dbi antenna that can be found here: https://www.nebra.com/products/glass-fiber-lora-antenna-peak-gain-5-8dbi/ The design has both screw holes and space on the back to mount 3M Command strips depending on your preferred method of mounting. The hole in the bottom allows the N type connector to fit through while not allowing the antenna to pass. The screw holes will fit a 5mm screw shaft and up to a 9mm head size. This mount should also fit any antenna that has a similar base width of about 23mm diameter. If you have any other antennas that fit, let me know so I can add them into the description. For a larger version of this mount that has been tested to work with the 90cm long RAK and Sparkfun LoRa antennas, visit this page: https://www.thingiverse.com/thing:4931860 Print Settings Printer Brand: Creality Printer: Ender 3 Pro Rafts: No Supports: No Resolution: 0.24mm Infill: 30% Filament: eSun PLA Silk Gold Notes: PETG or stronger recommended for extended use / for areas outside. Category: Electronics