Ncase M1 - EK D5 Pump/Res Mount

prusaprinters

<p>This is a mount for a EK D5 pump in the Ncase M1, the best small form factor case ever, for use with custom water cooling.</p> <h3>Features</h3> <ul> <li>Reuses the internal SSD mounting holes</li> <li>Perfect fitment</li> <li>Secure &amp; easy to remove</li> <li>Easy print</li> </ul> <h3>Requirements</h3> <ul> <li>3x M3 nuts</li> <li>3.5mm drill bit</li> <li>4x M4 12mm screws (from the EK D5 pump)</li> <li>3x SSD M3 screws with rubber inserts (from the Ncase M1)</li> </ul> <h3>Printing</h3> <p>Print in PETG or ABS if possible. PLA will work because it is not directly exposed to any heat, but will still not last as long.</p> <p>Use 0.24mm layer height or higher for better strength.</p> <p>Use 4 perimeters! Because that is where most of the force is. 3 top/bottom layers should be enough.</p> <p>30% or higher infill.</p> <h3>Instructions</h3> <ol> <li>Drill out the M3 holes with a 3.5mm drill bit</li> <li>Insert the three M3 nuts. This will be tight, so use a pair of pliers if needed</li> <li>Put on the three rubber-inserted M3 screws</li> <li>Screw the mounting plate to the D5 pump bracket, with four M4 screws</li> <li>Slot the entire assembly to the front frame of the case, where the internal SSD is supposed to go</li> </ol> Category: Computer