Naze32 oled screen holder

myminifactory

If you run Cleanflight on the Naze32 board (or any copy), you can attach one of those cheap miniature OLED displays. These displays are available from eBay and are handy for showing flight controller info before takeoff. The OLED displays themselves are pretty fragile, which doesn't fit well with mini quads. It's easy to connect the display to the flight controller, but finding a good way to mount it to the frame is tough. If you use double-sided tape to mount a display on your frame, there's a high chance that you'll snap off the unprotected lower corners of the display glass and instantly destroy the OLED (I've destroyed two of them). This design creates a protective frame that fits around the display, allowing it to be mounted to any flat surface using two screws. Just note that the connection pins need to be removed and replaced with cables soldered to the back side of the PCB - this is really easy. It's super important to clean up the surfaces surrounding the glass area of the display before mounting. If anything protrudes or the opening is just a bit too small, the display will crack when you try to mount it, making it instantly useless. But if you take your time, you'll be fine. I've also designed an alternative holder that lets you mount the display directly on top of the flight controller. This version uses the standard 30.5 mm hole pattern of the CC3D/Naze32 boards and can be found here: http://www.thingiverse.com/thing:682032