Navi - The Legend of Zelda

thingiverse

A friend of mine has a phenomenal Link cosplay and requested a Navi to complete his ensemble. They also asked that it could be opened to insert a voice box and/or LED lights so I made this to fit, and a hole in the top to insert a cord for hanging if you wish. The attached image of Navi was the inspiration for this design. -Print settings- Layer height: 0.1 mm Walls: 4 Infill: 0% Plate adhesion: Raft (0.15 mm air gap) Supports: Yes -Used zig-zag infill at 60% density, 0.6 mm air gap, on the body to hold up the rim above the rotating portion. Make sure to keep overhang angle waaay high, like 85 degrees, so that it only builds supports along the rim and not all within the hemispheres. -Used small but close (0.4 mm air gap) tree supports to support wings