Navage SaltPod Cheater PETG/PLA

thingiverse

Original was printed in TPU which I have discovered is quite forgiving from a tolerances perspective. A couple comments that when others tried it was too tight, so I took a pass at modifying and testing with PLA+ and then PETG. Some of the supports are really thin, but adjusted various components and got to a model that appears to work okay.Printed with tree support, have to be a little careful removing it. Tested in PLA+ and PETG and worked with both. Still a little tight on the hinge, but any looser and the top lever does not engage enough. Have not yet printed in TPU, but I anticipate it would work just as well or better as it has a little more give. The channel in the middle is much larger in this model than the previous and is still a snug fit, adjusted other components where there was pinch.