Nautilus Mount (RigidBot E3D v6)

myminifactory

Users install two 25mm M3 screws for the clamp. Original 8mm M3 screws can also be used to mount the base, but 16mm M3 screws would be even better suited. A 30mm fan is installed with four 16mm M3 screws or the included plastic fasteners. The original plate was lowered slightly by replacing bearing and belt mounts (parts 430288 and 430289). The extruder cable strain relief in the picture uses part 408352. This design comes in two versions. The older version does not cool the lowest fins on the E3D, but works with the original bearing mounts. The newer 32mm version raises the hot end to cool the lowest fin, requiring replacement of the bearing and belt mounts. The part cooling parts use a 50mm blower fan and aquarium airline tubing, and only work with the 32mm version of the mount. To print this design, support is required. The filament opening on the older mount should be drilled out slightly to get a smooth 2mm opening.