Narrow receiver box for Axial SCX10-3

thingiverse

This is a closed narrow box for rc-receivers, to fit the right side-panel of the Axial SCX10-3 crawler. It provides 2 cable outlets (end and inner side). The goal was to replace the original and relatively huge Axial receiver box, so scale- builders have a chance to fit a nice interior (at least from "knees up"). NOTE: Box is not water- or dust-tight without additional measures and not designed to be. It was especially designed for the following 6-channel-receivers (which are basically the same): Flysky FS-BS6 Absima R6FS Turnigy GT5 receiver Reely BS-6 Dimensions of these are: 29 x 22 x 16 mm (L x W x H) Fixation on side-panel with 3 metric screws from underneath (compare photo): 1x M3x10mm countersunk flat head (1.) 2x M3x10mm rounded head (2.&3.) I decided that one of the domes (see 3.) has to be chopped off, which is not a big deal, as the rock-sliders may still be fitted with the same screw from underneath into the receiverbox thread. Has to be drilled to 3.3mm. Fixation of receiver box cover: 4x M2.5x8mm metric countersunk flat head (same type as for original receiver box from Axial) I chose to print from PLA as it should be not too much temperature-load or UV-light on this part. At least for my printer and filament choise, it also looks much better. However, it should work for other materials as well. Cover is not designed to be a super tight fit with the housing, so there should be a small gap around always, even with shrinking materials. As always, hope you like it. Feel free to comment or post your makes. Best regards from Bernd's Custom 3D's