Narrow light switch frame

thingiverse

Since we purchased our house this frame has been missing and I've never spotted a replacement in the stores. So when my 3D printer arrived, this was the first project on the agenda! It's designed to make an interference fit snug with the switch, especially the nub clip-ins over the screws. For improvement: If anything, it's a little too tight, I think the nubs are slightly off-center. Also, not super fond of the color! I've had a suggestion of using wood filament, which is probably best in my case since I doubt 'old ivory yellow' is available. Print Settings Printer: Kodama Trinus Rafts: No Supports: No Resolution: 0.3mm Infill: 100% Notes: To print on my Kodama (which only has a 120x125mm build space), I oriented it at ~45deg. It will just fit, provided there are no rafts or supports.