NARCISSA MALFOY WAND - HARRY POTTER 3D print model

cgtrader

This is my exclusive Narcissa Malfoy Wand design. Inspired by the magical world of Harry Potter! This original model was crafted by me! Modelling took a total of 4 hours. This model boasts a high-resolution quality with an impressive 120,000 polygons. The wand features two parts, but I've included a full version as well - perfect for printing without splitting it later on. Created in Cinema 4D, this model is ready to be printed out and used. Please note: No support materials are included - you're expected to print directly from the design. When printing with 100-micron (0.1mm) resolution, you'll be surprised to find that no sandpaper or special finishing techniques are needed to achieve a flawless result! RECOMMENDED CREALITY CR-10 PRINT SETTINGS: Layer Height: 100 microns (0.1mm) Infill percentage: 40% No support required Bed heat: 60 degrees Celsius Nozzle temperature: 200 degrees Celsius Print time may vary, ranging from approximately 6 hours or more - this will depend on the size of your wand and model of printer. I truly hope you guys enjoy this design! If you have any questions regarding my designs or anything else, feel free to reach out via a direct message. Alternatively, if you'd like to make a bulk purchase, I'm open to that too! Thanks for following along, and I'll catch up with you on the next project! Don't forget to check me out on Instagram at @buyucusokagi @tolgaaxu. ABOUT THE WAND: In 1998, Narcissa handed her wand over to her son Draco after Harry Potter had taken it from him in a scuffle within Malfoy Manor. It remains uncertain whether she utilized another wand during this time period.[1] Draco eventually lost the wand inside the Room of Requirement while engaged in a fight with Harry for Rowena Ravenclaw's diadem, and the wand was subsequently destroyed as Vincent Crabbe set loose Fiendfyre in that very same room.