Naquadah generator USB-LED version

cults3d

Here is my upgraded Naquadah generator from Stargate. It has EL wire (white), LED's and USB socket so you can use as decoration but also to charge your phone. You'll have to remove electronics from EL wire from the case and solder positive to 5V on Arduino Nano and negative to GND on Arduino (check out the schematic). EL wire goes inside the large long cylinder (printed in clear PLA) and through the small clear rods on the sides. You can fold the wire and put all inside the large cylinder to increase brightness. Don't forget to press the push button permanently which normally switches EL wire, but we want it on so when you plug it to USB it will light up automatically. I used tape to cover the push button. The top of the Naquadah generator is empty inside so you can fit all the electronics and LED's. Solder Blue LED's to pins D2-D5 and Red LED's to pin D11-D12. You'll need a USB cable to power the Arduino Nano (check out the schematic) and another USB cable (male to female) to mount inside one of the side spheres, so you can then put your smartphone on charge. You end up with 2 USB cables (one to power Arduino and one as an extension for smartphone charging), so you'll need a mains plug with 2 USB sockets. It's not particularly easy to assemble this project, but if you're a Stargate fan it's definitely worth doing. If you need help with the assembly just message me. Your comments and advice are welcome.