NAPALM's Geeetech Prusa I3 Pro B single hand bed level

thingiverse

To level the bed, turn the screw from above while holding the lower wing nut in place with your other hand, or hold the screw steady and turn the wing nut below. With this simple component, you can level your 3D printer's bed using just one hand. Print this small part four times, install nuts inside, then swap them out for your existing wing nuts. From now on, leveling your bed requires only a quick turn of the screw from above. To see more projects like this, visit my collection at http://www.thingiverse.com/TheRealNapalm/collections/napalms-stuff If you enjoy my designs, consider using the TIP DESIGNER-button to show your appreciation and hit the Like-button above to share your enthusiasm. Thanks for your support. Print Settings: Printer Brand: RepRap Printer: Geeetech Prusa I3 Pro B Rafts: They don't matter much. Supports: Yes, you should use them. Resolution: 0.2mm is a great starting point. Infill: Start with 25% to get a good balance. Notes: I used a 0.4mm nozzle and kept the height at 0.2mm for best results.