Nanoleaf Canvas Linker

thingiverse

I designed my own linker to 3D print because I didn't want to pay $7/each for new linkers. Sharing the file here!A few things to note:3D printed linker is one-side only (it is not "double-sided" like original linkers).I added "triangle arrows" on the sides to show which side the exposed wiring should be on, to properly connect/touch the prongs on the canvas panel. Arrows also mark the "front face" of the linker.The big bulky areas near the middle (where the arrows appear) are for structural support and do not affect fitment, as PLA can be quite flimsy printed this thinly. (I didn't try to print this super-fine)As you can see, the middle (black) wire goes straight down the middle. The two wires on the sides (red and yellow) need to cross each other from one end to the other.I used 22 AWG SOLID core wire. I do not recommend stranded core wire because one of the small strands could possibly travel and touch a different wire and short the circuit.I added holes near the ends just in case a wire was long enough to wrap around and into the holes, but none of my wires really did. I just used needle nose pliers to pinch them around the sides and it was fine.PRO-TIP: After printing, do not test fit before adding your wire. If you test fit without adding wire first, the metal prongs in the socket on your panel may get stuck in the 3D printed linker and pull all the way out when you remove the linker. Yes, it happened to me and almost permanently damaged that prong. You can probably test fit by inserting just partly into the socket, but do avoid inserting all the way without wire. I highly recommend you add wire to this 3D printed linker FIRST before any test fitting. The metal prongs on the panels are fairly delicate.Just as a small disclaimer, I quickly want to say please only use at your own risk! I cannot be held responsible for any damage done to your system by using these 3D printed linkers. You may possibly be voiding warranties... Or exposing your Canvas system to possible electrical shorting if you do not build these properly. Attempt these only if you know what you're doing! Thank you!Be sure to check out my extension wire linkers![=]]---------------------------------------------------------[[=]