NanasOakTree

thingiverse

Human: Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=279864 Instructions Using the following options: Length maximum ratio is set to 100. Allowed overhang angle is set to 50 degrees. Tip maximum ratio is set to 70%. Root minimum ratio is fixed at 50%. Branches are kept growing at a rate of one. Base shape is set to 0. Tip minimum ratio is locked at 50%. Minimum branching angle is set at 40 degrees. Budding starts at position 19. Custom shape is defined as: [[[0, 46.278908], [-15.319993, 17.365068], [-47.552826, 11.729756], [-24.788267, -11.775289], [-29.389259, -44.171944], [0.000001, -29.785017], [29.389269, -44.171940], [24.788267, -11.775290], [47.552826, 11.729764], [15.319985, 17.365074]], [[0, 1, 2, 3, 4, 5, 6, 7, 8, 9]]]. Use of advanced settings is disabled. Maximum branching angle is set to 55 degrees. Allowing all overhangs is switched off. Branch twist angle is zeroed out. Minimum number of branches from each branch is set to three. Maximum number of branches from each branch is capped at five. Branch cross-section shape is defined as six. Trunk length is fixed at 40 units. Seed value is locked at zero. Trunk radius is set to ten units. Branch diameter cutoff is set to 1.6 units. Length minimum ratio is locked at 70%. Budding stops at position 86. Root maximum ratio is capped at sixty. Maximum branching iterations are limited to seven.