Name Your Price Tool

thingiverse

My wife decided to go as Flo from the Progressive commercials for a Halloween bash and I couldn't locate the Name Your Price Tool on any of the typical websites. I managed to find a decent blueprint that helped me sketch this out in Fusion 360. After printing it, I noticed the pins were slightly too large/long, so I adjusted them before uploading. The top pieces turned out a bit thin towards the back, so I made them thicker. I haven't tested them yet, but they should print just fine and be better than my initial prints. Support is mainly required for the body pieces. Where the trigger goes, there's a slight overhang, so you might get away without support, but it's always safer to err on the side of caution. To assemble this, all you need to print one of each piece except for the pins, which require 9. Then I used some 5-minute epoxy to put everything together and it held up great at the party. This is more of a prop than anything else, so the front isn't open like in pictures. I might revisit this and maybe integrate a laser pointer into it? We'll see what happens.