Naked Runcam Thumb Pro
thingiverse
First attempt at a naked thumb pro. This saved me 11g over the mount i was using on the foxwhoop. Cam is easy to strip, just remove the screws. Note to use this mount you must clip down the battery connector and direct solder (you can add a connector further up the wire). Mount is for Foxwhoop 25 approx 13.7g without lens cover 15.9 with cover and ND filter Thumb pro no base is just the mount itself. Note both files need the SD card plate. This is attached with the two longer screws removed from the thumb pro which screw into the lens base. You need to heat the mount up to get the naked thumb inside. Note this is a first attempt. Front section is good, SD card plate needs a little work. Two ND filter options. Stock one fits the ND filters that come with the cam. The second round one is the one I use on a modded Hero 7 lens. Note, if you want to use it with runcam RC18G etc, you'll need to make the hole slightly smaller as the hero lens is wider. It fits the SMO4k Cam ND filters. Edit - added ND filter holder for stock one and SMO4k for wider angle lens. Edit - added a version with a covered back as might be able to get the board in like this when tpu is heated up. Untested. Printed with Sainsmart 65% infill 198 tip and 60 degree bed (ender 3)
With this file you will be able to print Naked Runcam Thumb Pro with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Naked Runcam Thumb Pro.