N-STRIKE BARREL LUG FOR NERF STRYFE-X

prusaprinters

This is a replacement muzzle for the Nerf Stryfe X that gives it an N-Strike barrel lug so it can use Nerf barrel extensions. For printing this part, I recommend orienting it muzzle down and with tree supports for the best results. If you plan on using the sling point you should go with a high wall count for added durability.For installation, first make sure your battery is removed, take all the screws out on the left side of the shell, open the blaster, take out the 4 screws on the flywheel cage, then lift the cage up slightly and pull the stock muzzle up and out of the blaster. From there, replace the stock muzzle with the new one, ensuring that it seats into the flywheel cage and over all the screw posts. If the cage isn't seated properly the muzzle won't go in right, so make sure everything is sitting in the shell correctly. Then just put the 4 screws for the flywheel cage back in, put the other half of the shell back on, and tighten all of the screws. From there you should be finished.FOR ANYONE REMIXING THIS FILE: While I encourage remixes, I ask that you don't sell any parts derived from this file, as designing the parts that make it fit into the blaster took a lot of work and I expect some people may want to use this file to make their own muzzles for the Stryfe-X using the mount from this design.IF YOU WANT TO SELL THIS MUZZLE OR YOUR REMIXES OF IT: Please contact me and we could work something out but this file remains completely non commercial unless I say otherwise.WARNING: Modified blasters will most likely void warrantees. By modifying your blaster you risk damaging or breaking it.