MySensors Ethernet Gateway Box for iBoard v2.0

thingiverse

This is a box designed for an iBoard that serves as an Ethernet gateway for MySensors. This model comes with features like radio LEDs and an inclusion button, plus reinforced pillars to provide stability. Instructions First, print the box without using a raft or any supports. However, make sure to use full support in order to achieve the best possible results. Then, print the lid face downwards. Please note that there are two different versions of this design: one specifically designed for micro push buttons with 7mm threads, and another for bigger buttons with 10mm threads. Securing the board and the lid can be done using #4 x 6mm screws. For those looking to get started with their iBoard, it's highly recommended to refer to the detailed instructions found here: http://forum.mysensors.org/topic/224/iboard-cheap-single-board-ethernet-arduino-with-radio/5. Additionally, be aware that making hardware modifications might not be necessary if you opt for soft SPI.